Author Topic: Removing exhaust servo motor  (Read 1702 times)

CdRsKuLL

  • Fat dude
  • Administrator
  • Hero Member
  • *****
  • Posts: 1556
  • Karma: +0/-0
    • MSN Messenger - cdrskull@msn.com
    • View Profile
    • Email
Removing exhaust servo motor
« on: April 10, 2009, 07:36:29 AM »
This is removed when fitting an aftermarket exhaust. You will then get a warning light on the gsxr clocks. Doing the below i'm told will remove this light..

In order to prevent a warning light appearing on the dash now that the exhaust valve has been removed it will be necessary to remove a pin from the fuel injection computer. Disconnect the two connectors from the computer. Take the larger of the two connectors and from the rear identify pin number 33 with a black and brown wire (see diagram). On one side of the front of the connector are two white tabs, on the opposite side is a single white tab. Push in the single white tab; the two white tabs on the opposite side will push out. Pull the black and brown wire of pin 33 out of the back of the connector and the pin will come with it. Push the two white tabs back into place to lock the remaining pins. Wrap some electrical tape around the pin and tape it to the wiring harness. Re-connect harness to computer.



Will let you know when I get round to this..

 

Advert