News:
Welcome to the Forums
Home
Forum
Help
TinyPortal
Search
TinyPortal
Downloads
Login
Register
Extreme Owners Club
»
Forum
»
Extreme Kits
»
Extreme 360
»
360 Build Tips and Advice
»
Panel Fit - Rear
« previous
next »
Print
Pages: [
1
]
Author
Topic: Panel Fit - Rear (Read 1556 times)
Drew355
Administrator
Hero Member
Posts: 942
Karma: +0/-0
Panel Fit - Rear
«
on:
October 09, 2008, 01:58:13 PM »
Bootlid
Rear light Panel
The rear lights on the 360 should be fitted with the bulb holder on the back of the unit in a horizontal position. This will mean the left and right halves will light up rather than top and bottom.
The flat section of fibreglass in the centre of the rear light panel should be cut out with the tabs remaining for the light units to bolt onto.
(Pic - Xpert360)
To enable the inside lights to fit, the steel section they foul on will need to be removed. (See Xperts pics in posts below) This section is only to support the frame until the boot floor and rear panel steel sheets are welded in.
«
Last Edit: October 10, 2008, 12:26:04 PM by Drew355
»
Logged
XPERT360
Extreme Owner
Hero Member
Posts: 1024
Karma: +0/-0
Re: Panel Fit - Rear
«
Reply #1 on:
October 09, 2008, 11:13:43 PM »
tip, note to myself always look at the dvd for reference
OK TOOK YOUR ADVICE AND SORTED OUT TONIGHT.......
DO NOT CUT VERTICAL TABS OFF AND ROTATE THE LIGHT AS I DID. THIS NOW SHOW NEW METAL TABS BONDED BACK TO THE CORRECT PLACE LIKE THE OUTSIDE LIGHTS.
JOB DONE, ALTHOUGH WITH A SILLY LITTLE MISTAKE.
«
Last Edit: October 10, 2008, 12:24:25 PM by Drew355
»
Logged
Print
Pages: [
1
]
« previous
next »
Extreme Owners Club
»
Forum
»
Extreme Kits
»
Extreme 360
»
360 Build Tips and Advice
»
Panel Fit - Rear
Advert