Hi,
Hopefully someone on here can help me out with some mechanical question
The rear suspension on my 360 uses the damptech setup which is fully adjustable. When I got the car the rear suspension was at it's lowest ridge height and when the car was raised off the ground the rear springs just fell out of their seating positions. I had the car raised by about 2 inches when the MOT was done but feel it needs to go a little higher. The exhaust catches on th ground all the time when driving over the slightest bump and whilst I can raise the exhaust a little I want the whole rear end raised about 1 inch.
The problem is that when I jacked the car up the rear springs are firmly in place. How do I get them out to adjust the screw base? Will I need some small coil compressors and what are the best ones to use. Any help would be much appreciated.
This photo shows the coil with the slightly rusty screw base and the exhaust section is the matt black tube going across the bottom.
This slightly better photo shows the coil to the left, the exhaust in the middle and the rear brake and suspension parts are the rusty ones on the right. Who'd have thought that most were new 12 months ago!